Skills

General

  • Engineering Design for Greenfield projects
  • Engineering Design for Brownfield projects
  • Engineering Design for Debottlenecking projects
  • Perform Independent Design Review / Validation
  • Conduct PDMS Model Review, Design Integrity Review, Inter-Discipline Check Reviews etc.
  • Participate in HAZOP, HAZID, ELSOR, SAFOP, SIL etc.
  • Perform TBE, VDR/VDI for vendor packages
  • Perform site survey for modification scope of works

 

Process

  • Perform detail process design and design assessment reviews
  • Develop Process flow diagrams (PFD), Piping and instrumentation diagrams (P&ID) and Material & Energy Balance
  • Perform flare and blowdown studies, pipeline flow assurance study
  • Develop process and pipeline simulations
  • Develop alarm and shutdown matrix, safe charts
  • Perform calculations for equipment design and sizing
  • Develop equipment process datasheets
  • Develop Start-up and operating manuals

 

Mechanical & Piping

  • Preparation of optimised equipment layouts
  • Prepare Mechanical studies and reports
  • Perform Material handling study
  • Equipment Selection, specifications, datasheets and Material specification
  • Develop Master Equipment List
  • Complete 3D PDMS Modelling
  • Rotating equipment and pressure vessel sizing, fabrication drawings
  • Design of Utility systems, Fire water, Deluge and Sprinklers
  • Estimation : Cost and weight
  • Pipe stress analysis, calculations and reports
  • Pipe supports modelling and detail drawings
  • Conversion of Laser scanning Model to intelligent PDMS model

 

Electrical

  • Power Generation and Distribution system (HV & LV, Selection and Sizing)
  • Development of electrical Load List & UPS load list
  • Main equipment sizing (Generators, Transformers, UPS, Switchboards etc.)
  • Design and Sizing of Cables, Heat tracing, Batteries, Indoor/Outdoor lighting, Grounding, lightning design
  • Design and Develop Load shedding schemes, Power Management Systems, ECMS and IMCS System architecture.
  • Power system analysis (Short circuit, Load Flow, Motor starting & Relay co-ordination)
  • Single line diagrams, Schematics, Control and protection diagram, Interconnection diagram
  • Electrical room, Battery room, electrical equipment layouts and modular type E-house
  • Perform Adequacy check for equipment
  • Design of Navigational aids system, helideck lighting system in compliance to codes and standards.

 

Instrument

  • Design and develop System Architecture
  • Design and selection of SCADA, DCS, ESD & FGS Systems
  • Develop Philosophies for DCS, SCADA, ESD, FGS
  • Develop Instrument index, I/O list, Instrument Datasheets, Loop Diagram, Layout Diagrams and Cause and effect matrix
  • Develop layout for instruments, Fire and gas systems, PAGA systems, CCTV systems and cable trays.
  • Selection and sizing of Control Valves
  • Perform Adequacy check for modification of system

 

Structural

  • Perform Hydrodynamic analysis of offshore structures
  • Expertise in Marine engineering related to offshore structures
  • Perform beam and finite element analysis of offshore structures
  • Perform Inplace Analysis for various operating conditions
  • Perform Lifting Analysis, Transportation Analysis, Load Out Analysis, Fatigue Analysis, Pile Analysis and Seismic Analysis
  • Perform Buckling Analysis using DNV Pilot and Framework
  • Perform Skid Lifting arrangements and Weight control report
  • Structural Modelling
  • Decommissioning study